How To Use: iPAD SP1 Fully-Automatic Defibrillator

When someone collapses and isn’t breathing, time is critical. The iPAD SP1 Automated External Defibrillator (AED) is designed to help you act fast, even if you’re not medically trained.

Here’s how to get it ready, use it correctly, and keep it in good working order.

Getting Set Up

Feel free to download and share this graphic!

Start by taking the iPAD SP1 AED out of the box. Check that the electrode pad lead is already connected to the front of the device and that the pads are stored in the compartment on the back.

Insert the battery pack into the side of the AED, following the arrow on the label. Push until it clicks. The device will run through self-tests — follow the prompts and press any flashing buttons when asked. Once complete, the AED will shut itself off.

Check the status window on the front. You should see:

• A circular status indicator
• A full battery symbol
• A full pads symbol

If all three are visible, the AED is ready. Place it into the orange carry case and gently feed the pad pull-tab through the slot so it’s easy to access.

Using the AED

In an emergency, follow these steps:

1. Turn it on. Press the green ON button. A green light next to the pad connector confirms the pads are connected. Flashing means check the connection.
2. Follow the instructions. The AED provides spoken and visual guidance for pad placement. Don’t worry if you move faster than the voice prompts — it will keep up.
3. Stand clear. If a shock is required, the AED will tell you to step back, charge, and then instruct you to press the flashing orange shock button.
4. Start CPR. The device guides chest compressions. Press the flashing blue “i” button for timed CPR instructions, a metronome, and breathing prompts. If not pressed, the AED will still prompt reanalysis automatically.

If the AED says “No shock advised,” begin CPR immediately. You cannot accidentally shock someone who doesn’t need it.

Continue until the person shows signs of life or the AED tells you to stop for rhythm analysis (usually every two minutes).

Key Features

• Child Mode: Lift the cover and slide the front switch to child mode. No need to change pads.
• Noise Detection: Automatically adjusts volume for loud environments.
• Data Recording: Stores up to three hours per incident and the last five events. Data can be accessed via SD card or infrared using free iPAD software.
• Event Summary: Turn the AED off, hold the blue “i” button for over a second, and it will report CPR duration and shock count.

Regular Checks

Although the AED runs daily, weekly, and monthly self-tests, regular visual checks are still important.

Check the status window for:

• Status indicator: A circle means OK. A cross indicates a fault. A flashing red “i” button provides more details when pressed.
• Battery indicator: One bar means order a replacement. Zero bars means replace immediately.
• Pads indicator: Full means in date. Half means expiry within three months. Empty means pads are expired and must be replaced.

Final Word

This guide doesn’t replace hands-on training, but it should help you feel more confident using the iPAD SP1 AED.

For additional support or a video walkthrough, visit www.ipad-ed.com.

Stay prepared. It might just save a life.